I had a great time working the ARRL CW November Sweepstakes contest this year. I know that many Hams do not care for SS with the long, complicated exchange but I think it is a great challenge. After many years of trying and hoping, I finally managed to work all 84 Sections for the "Clean... Continue Reading →
An SO2R Antenna Switching Project using N1MM
I have decided to revive a project that I started over a year ago, but had put on hold. My Station is setup for SO2R operation but I do not have automated antenna switching in place. I have 3 or 4 antennas, depending upon the contest, and manually connect and disconnect them as the contest... Continue Reading →
Important N1MM+ Antenna Config Changes
I just installed the latest version on N1MM+. I have been looking at using the Antenna Data provided by N1MM+ for controlling my antenna switching. In the latest version, the Change Log shows two changes that were made to the Antenna Configuration table: Alt-F9: Fix issue with 1.8 and 3.5 in Antenna table when country/locale... Continue Reading →
Using N1MM+ Serial (OTRSP) Data for Two-radio Antenna Switching
I have been investigating ways to automatically switch antennas in a 2-Radio (SO2R) station for use in Contesting. Using multiple antennas is nearly a must for HF contesting, including Yagis, Veticals, and any of a variety of wire antennas. When working a Contest, Band Switching is a key time-waster, and steps need to be taken... Continue Reading →
Using N1MM+ OTRSP Data for Antenna Switching – 2020 Update
I have been looking at antenna switches for using two radios with a number of antennas. The common switches I have found are referred to as "Six packs" or 2X6 antenna switches, which establish connections for 2 radios to any of 6 antennas. N1MM+ provides antenna selection information in a serial data stream via the... Continue Reading →
DXDUSB Next Version with Custom PC Board – UPDATED
After using some DXDUSB prototypes with DX Doubler SO2R boxes for several months, I finally got around to completing the PC Board layout for the next version. This one will add some power conditioning and choice of operation from +5 or +12 VDC. It also should be able to survive use in a Mobile environment... Continue Reading →
DXDUSB – DX Doubler USB Interface Update
DXDUSB Development Status I have had some requests to provide DXDUSB prototypes to couple people. The latest prototype (Protot3) is still very rough. I have a couple in ongoing testing and they seem to be working well. However, these are very rough - assembly is hand soldered wires attached to the Arduino board. While I... Continue Reading →
A USB Interface for the DX Doubler – The Last DXDUSB Prototypes
I have been working on a USB-only interface for the Top Ten Devices DX Doubler for some time. I recently completed the 3rd generation prototype. This is still a prototype - it uses a very small Arduino board with attached wires, but it is shoved into a nice small Ethernet drop-box enclosue. This version has... Continue Reading →
DXDUSB DX Doubler USB Interface – 2nd Prototype
The 2nd prototype of the DXDUSB Interface has been completed. I ran it hard through the recent NAQP CW contest, and it did very well. Now it is just a matter of finalizing the software (of course software is never really "final"). Here is a look at the 2nd prototype Next i will be designing... Continue Reading →
USB For DX Doubler First Prototype
I recently completed testing of the first prototype of the USB interface for DX Doubler using N1MM+ software. This was a rough prototype, so it isn't pretty but it does seem to work fine. It currently handles RX and TX Focus, and STEREO for listening to both radios at once. There is an FTDI chip-based... Continue Reading →
Kg3v Ham Radio Blog 